Klarfit Barracuda Mode D'emploi page 25

Changing the propeller
Attention
Make sure that the motor has been disconnected from batteries.
• Hold the blade of the propeller and loosen the propeller nut with the
included wrench or a set of needle nose pliers.
• Remove the propeller nut.
• Pull the propeller straight down.
• If the propeller gets stuck, hold one blade by hand and carefully beat
the back of the other blade with a rubber mallet until the propeller
disengages.
• If the propeller pin is bent, replace it.
• Place the new propeller on the propeller pin.
• Replace the propeller nuts and tighten them by hand.
• Finally, tighten the propeller nuts by a further 1/4 turn with the wrench.
Step 1
Caution: Never attempt to remove a bent propeller pin by hitting it with a
hammer, as this could damage the engine mooring. Any resulting damage will
not be covered by the warranty.
Step 2 Step 3
EN
25