Publicité
Liens rapides
DUCTLESS KIT (#DUCTCLAS) INSTALLATION INSTRUCTIONS
INSTRUCTIONS D'INSTALLATION DE DUCTLESS (#DUCTCLAS)
FOR USE WITH THE FOLLOWING PRODUCTS:
POUR L'USAGE AVEC LES PRODUITS SUIVANTS:
This kit consists of:
A) 2 CHARCOAL FILTERS
B) DUCTLESS DIVERTER
CLASSICA 30 (CLAS30SS)
CLASSICA 36 (CLAS36SS)
Ce kit se compose :
A) 2 FILTRE de CHARBON DE BOIS
B) AIGUILLAGE SANS CANAL
B
A
Version 02/11- Page 1
Publicité
Manuels Connexes pour Faber CLASSICA 30
Sommaire des Matières pour Faber CLASSICA 30
- Page 1 DUCTLESS KIT (#DUCTCLAS) INSTALLATION INSTRUCTIONS INSTRUCTIONS D’INSTALLATION DE DUCTLESS (#DUCTCLAS) FOR USE WITH THE FOLLOWING PRODUCTS: POUR L'USAGE AVEC LES PRODUITS SUIVANTS: CLASSICA 30 (CLAS30SS) CLASSICA 36 (CLAS36SS) This kit consists of: Ce kit se compose : A) 2 CHARCOAL FILTERS...
- Page 2 FOR DUCTLESS INSTALLATIONS (SEE HOOD INSTALLATION INSTRUCTIONS FOR FURTHER INSTRUCTION ) The UPPER CHIMNEY COVER must be installed first, before the LOWER CHIMNEY. 1. Install the non-vented (ductless) diverter supplied with the recirculating kit. See (FIGURE 1) 2. Fit the diverter over the vent exhaust outlet and push down to seat on outlet. Check that the diverter exhaust outlets are parallel with the vent motor sides so that they will align with the vent cover openings in the lower chimney.