Panasonic CZ-TAW1 Guide D'installation page 5

● Request installation only from the place of purchase or an
installer�
– Not doing so may cause electric shock or ignition.
● Shut off the power supply when installing this adaptor.
– Not doing so may cause electric shock.
● Use only the specified parts when installing the adaptor and
perform the installation correctly by following the instructions.
– Not doing so may cause electric shock or ignition.
● Ensure cables are installed properly so that external forces
cannot affect them�
– Not doing so may cause overheating which can lead to ignition.
● Make sure the adaptor is installed with the cable ports facing
down.
– Not doing so may allow water to enter the adaptor and cause
electric shock or ignition.
● The adaptor is indoor use only. Do not set up outside or in
unsecured locations�
– It may provide an entry point for unauthorised network access.
● Do not set up in locations exposed to direct sunlight, where
the temperature may exceed 40 °C or go below 0 °C.
– This can cause deformation.
● Do not install in locations where oils are used a lot or where
steam or sulphurous gases are emitted�
– This can cause loss of performance or deformation.
● Before connecting wires and cables, discharge any static
electricity.
– Not doing so may cause malfunction.
WARNING
CAUTION
5