Wire Gauge And Length - Jandy Pro Series Nicheless LED Underwater Light Manuel Du Propriétaire

Page 8
3.2 Wire Guage and Length
Jandy Pro Series Nicheless Underwater LED Lights are low voltage
®
fixtures. Improper wire guage and wire length can effect the performance
of these products. Follow the guidelines below to determine the proper
operation and optimum performance of the lights.
Voltages are determined by the measured voltage level at the Bus Bar
where the transformer and cords are connected.
NOTE: Each color mode has a slightly different power draw
JLU4C9W/JLUW9W/JLU4C20W/JLUW20W Min/Max Voltage per cord length
Cord Length
50 Feet
100 Feet
150 Feet
JLU4C30W & JLUW30W Min/Max Voltage per cord length
Cord Length
50 Feet
100 Feet
150 Feet
RISK OF ELECTRICAL SHOCK OR ELECTROCUTION,
which could result in serious injury or death.
Circuit Interrupter (GFCI) for 120 Volt transformers should be used if
required by the transformer manufacturer or if required by the local
applicable code and/or Authority Having Jurisdiction (AHJ). When
a GFCI is used, the conductors on the load side of the GFCI circuit
shall not occupy conduit, boxes, or enclosures containing other
conductors unless the additional conductors are also protected by a
GFCI. Refer to local codes for complete details.
ENGLISH
CAUTION
Min. Voltage
9.4VAC
10.7VAC
11.82VAC
Min. Voltage
10.34VAC
10.9VAC
11.43VAC
WARNING
Nicheless Underwater LED Lights | Owner's Manual
Max. Voltage
12.4VAC
13.2VAC
13.8VAC
Max. Voltage
12.56VAC
13.5VAC
14.1VAC
A Ground Fault