Operation - Haussmann EST100 Guide De L'utilisateur

ASSEMBLY
POSITINING THE AUXILIARY HANDLE (Fig. 10)
1.Move and rotate the auxiliary handle to a position that is comfortable to you
2.Tighten the knob.
ADJUSTING THE SNOW SHOVEL HEIGHT (Fig. 11)
1.Loosen the knob.
2.Set the tube to a height that is comfortable for you by sliding the upper handle
to your desired height.
3.Tighten the knob .

OPERATION

Before using the machine, please make sure:
The power source you will use is in accordance with the specifications shown in
this manual. Before inserting the plug into the socket, make sure the machine's
roll shaft and the snow blow rubber plates are all fixed firmly with screws, and the
rubber plates are facing to the correct direction.
STARTING SNOW SHOVEL
1) First, press the button on the side of handle grip.
2) Then squeeze the trigger.
3) To stop the product, release the trigger.
OPERATING SNOW SHOVEL
Start the snow shovel and tilt it forward until the scraper blade contacts the
ground. Push the machine forward at a comfortable rate of speed, slow enough
to clear the path completely. The width and depth of the snow determines your
forward speed.
Direct the snow to the right or the left by holding the snow shovel at a slight
angle.
For the most efficient snow removal, throw the snow downwind.
22
EST100
Figure 10
Figure 11