Cutting Applications; Table Mounting - Freud FT1700VCE Notice Technique

CUTTING APPLICATIONS

Consider the material that you are cutting and
the amount of material that will be removed
before using the tool. Make sample cuts on
scrap wood before cutting the actual work piece.
WARNING! Always clamp your work piece
securely before making any cuts.
The router bit rotates in a clockwise direction
when viewed from the top of the router. On
external edge treatments move the router
counter clockwise from left to right. - Fig. 8a
WARNING! Avoid climb cutting (moving the
router clockwise with the rotation of the bit.
- Fig. 8b. Climb cutting increases the potential of
loosing control of the router and possible injury.
Tip: When creating an edge treatment on all
four edges, begin with the end grain of the
board first. If tear out occurs at the end of
this cut it will be removed when the cut is
made along the edge or with the grain.

TABLE MOUNTING

The Freud FT1700 can also be mounted to a router table. To mount the router, please follow the
instructions included with the router table.
English
CORRECT
INCORRECT
15
Fig. 8a
Fig. 8b