Nolangroup n-com S Serie Mode D'emploi page 10

EN
 Insert the microphone connector in the electronic plate (Fig. 13).
Fig. 13
 Replace the polystyrene cheek pad (left side), positioning the cable in the groove that you see in
the cheek pad.
Note: Make sure the cheek pad is properly positioned in its housing, pushing in the lined corner
underneath the ribbing on the shell.
 Replace the polystyrene cheek pad (right side), positioning the cable in the groove you see in the
cheek pad.
ONLY FOR FULL-FACE HELMETS: Insert the chin guard (microphone side), gently placing the
microphone in its housing. Then press down on the red tab until the chin guard is locked in place on
the helmet.
 Position the comfort padding in its housing (see specific instructions provided in the helmet user
manual), hooking the neck roll.
 Position both the comfort cheek pads in their housing (see specific instructions provided in the
helmet user manual) making sure that all the press-studs click.
Note: Carefully check the proper final positioning of the cheek pad, pulling the chinstrap toward the
inside of the helmet and testing the press-studs.
Caution: Make sure that there are no cables sticking out of the helmet and that the loudspeakers are
in their housing.
10
Fig. 14
 Position the left and right
speakers in the respective
housing obtained in
polystyrene cheek padding.
If necessary, secure them
using the adhesive strips
supplied as
equipment.
the
standard