Backup Power - Oregon Scientific +ECO RM336PES Mode D'emploi

CHARGING LED on solar panel will light up indicating
there is sunlight and unit is charging.
TiP
Press and hold TEST located at the back of the solar
panel. (Green) FULL LED indicates batteries have been fully
charged.
4. Align holes with protruding plastic. Push solar panel
towards main unit and snap into place.
5-6 hours of battery charging will normally provide power to
operate unit for 2 months (without using projection feature)
or  week (using sleep and alarm projection feature daily).
When the rechargeable battery is nearly flat or when solar
panel has been detached, the (green) LED indicator on the
main unit and will flash.
TiPS
• For best results when charging the battery, place the
solar panel directly with view to sunlight.
• Direct solar panel as follows:
Solar panel facing:
North
South
• Do not scratch the solar panel's surface or wipe it with
strong detergent.
• Do not expose the solar panel to rain, snow or
moisture.
• The duration of the rechargeable battery's charging or
operating time is determined by either the intensity of
sunlight or the position of the solar panel towards the
sun.
• Do not overcharge the batteries.
P/N: 300102498-00001-10 REV1
6/72
if you reside in the:
Southern Hemisphere
Northern Hemisphere

BACkUP POwER

1 piece AAA battery
In the case when the rechargeable battery is flat or nearly
flat or when the solar panel has been detached, the AAA
battery can act as backup power supply for the main unit.
. Remove the battery compartment located at the base of
the unit.
2. Insert the battery, matching the polarities.
3. Press RESET after each battery change.
NOTE
When the rechargeable battery power is exhausted
or when the solar panel has been detached, the backlight and
projection functions will be disabled and the performance of
the radio controlled clock may be affected.
Power adapter (not included)
The adapter powers the unit and can also be used for
charging the rechargeable battery. When connected to the
main unit, will be displayed and projection feature can
reach its maximum brightness.
Plug AC/DC adapter into socket. Make sure the adapter is
not obstructed and is easily accessible to the unit.
To completely disconnect from power, the adapter should be
disconnected from the main unit.
NOTE
The main unit and adapter should not be exposed to
wet conditions. No objects filled with liquid, such as vases,
should be placed on the main unit and adaptor.
4