ROBENS ZY-CL502 Mode D'emploi page 2

LIGHT MODES
• Press the button for warm light (700 Lm)
• Press the button twice for cool light (300 Lm)
• Press the button three times for warm and cool together
(1000 Lm)
• Press the button four times for flashing mode
• In the first three modes, press and hold the button to dim
the light
USE OF THE LAMP
• Open battery compartment by rotating the lid counter
clockwise
• Insert 3 x 1.5V D batteries (not included), observe polarity
• Power indicator will light green when lamp is on, when
power is low it will light red
• Power indicator will flash green when off, to allow easy
finding of lamp in the dark
• Please use batteries of high quality and take out the bat-
teries if you do not use the light for a long time, or the light
can be damaged by electrolyte leakage or battery explosion
which is caused by low quality battery
• Please clean the contacts of your light from time to time,
especially if the light flickers or doesn't light up
• Lamp can be used hanging from the hanger, standing, or
hanging from the hook
• To remove the lampshade, rotate it counter clockwise from
the body of the lamp
• Lamp can be cleaned with water and a damp rag
• Lamp is water resistant to IP44
• Do not use corrosive liquids to clean the lamp
• Do not stare into the light source
• Do not modify the product
2
LIGHT SOURCE: 12W LED
TECHNICAL DATA
4.5V (3x1.5V D not included) ,
Class 3 appliance
DISPOSE OF PRODUCT ACCORDING TO
LOCAL REGULATIONS.
12W