asalvo ELITE-FIX 19097 Manuel D'instructions page 27

EN
INSTRUCTIONS
Press the ISOFIX button to pull
out the two locking arms from the
base bottom. Pull the locking arm
to and for until you hear an audible
CLICK which indicates they are fully
engaged.
And on both sides of the locking
arms ' button turn into green safety
color.
Pull out the top tether, and press the
release button, pull the top tether
long enough to hang the latch on the
back of the car seat.
Fixed the latch on the fixed point,
and the position of the fixed point
are shown in the picture(one of the
three positions).Make sure the hook
is tightened up.
(100-135 cm)
NOTE: When you use this safety car
seat in(100-135cm), please remove
the 5-point harness, sleeping pads
and the triangle pads refer to Chapter
4.2.
Place the child seat forward facing
on the vehicle seat (in the direction
of travel).
Put the ISOFIX insert guide into the
^
two ISOFIX attachment points of
_
your vehicle.
NOTE: The ISOFIX attachment points
are located between the surface and
the backrest of the vehicle seat.
Press the ISOFIX button to pull
out the two locking arms from the
base bottom. Pull the locking arm
to and for until you hear an audible
CLICK which indicates they are fully
27