Drive Medical DRIVE DELUXE 3 Mode D'emploi page 2

assembly
Please read these instructions before assembly or use of
this Rollator. This Rollator must always be assembled and
fitted for the user by a qualified Drive Medical Authorized
dealer. Before using your new Rollator please ensure that
your weight is within the weight capacity of this unit. This
Rollator will require very little assembly and the assembly
can be completed without tools.
assembly instructions
1. To open your rollator, pull both side frames outward.
Push the folding hinge with the black handle until
straight to secure the unit in the proper position.
2. Place a handle bar in each handle bar receptacle
and adjust to the desired height. The brake cable
should remain on the same side as the corresponding
wheel. Do not cross cables. Insert locking knobs into
adjustment holes and tighten to secure handle in place,
making sure both handles are at equal height.
3. Slide wheels back until push pins pops through the
adjustment hole located on the bottom section of
the wheel frame. Lock wheels in place by inserting the
locking knobs into the top section of the wheel frame
and tightening until secure (figures 1 & 2).
1
4. Test and adjust the loop lock mechanism tension to
ensure proper and secure locking before use.
5. Mount the basket in the proper location above the
rollator pouch, between the handle bars.
NOTE: To assemble basket, see next section on basket
assembly.
basket assembly
C
D
A
B
1
1. Fold back of basket (A) forward
and attach to first side (B) using
the small assembly hook located
on the side of A. Hook should be
on the INSIDE to assure proper
assembly.
3
3. Slide side D past the 2 small hooks located on B and C and secure in
place by sliding D backward to fit into the 2 hooks. This should be done
simultaneously.
locking knob
2
2
2. Fold second side (C) upward and
attach it to back of basket (A)
using the small hook located on
the side of A.
4