Boiling Water - Tiger PDU-A Manuel D'instructions

3

Boiling Water

Before first use / When not used for a while
Be sure to clean the unit before use.
There may be a smell of plastic when
first used. This is normal and will
diminish with use.
1
Open the lid.
Open
You may hear rattle sound when
opening /closing the lid. There is a
valve in the outer lid for prevention
of water spillage.
2
Pour water into the unit
with a separate container.
Fill water to level between "Max water level" and "Refill
water mark".
Do not splash water
onto the operation
panel.
M
• Do not fill water directly from a faucet.
Caution
Do not place the unit on wet surface.
• Automatic Boil cycle may not work
when refilling hot water above 122°F,
be sure to add lukewarm water or cold
water or press
(See
p. 11
• Do not exceed "Max water level". Do
not boil water if the water level is lower
than refill mark.
1. Add water to max water level and then bring up to boil. (See below)
2. After water is boiled, use electric dispenser button to discard half of hot
water. (See p. 12)
3. Unplug the power cord, open the lid and then discard the rest of hot
water. (See p. 18)
Push
Pour slowly.
Max water level
MAX
The highest level to which
water can be poured
Re ll water
mark
key.
Re-Boil/Timer
)
3
Close the lid.
Hold both side of lid
and close it securely
If the lid is not closed securely, hot water
Caution
may spill and cause scaling.
4
Connect the power cord.
Appliance
plug
Plug in
Receptacle
5
Boiling starts.
Light
illuminates
※ Refer to p. 11 when selecting the temperature for
Warmer. ( If no selection is made, a temperature of
194°F will be automatically set. )
※ Refer to p. 14 for setting the power-saving timer.
■Eliminate chlorine smell
• Press Re-Boil/Timer key once.
※ extend boiling time
Beeping
sound
Flashing
Plug
Beeping
sound
Plug in
Outlet
Flashing
Flashing
10 10