Replacing An Oven Light; Replacing The Control Knob Led - Furrion FTRD22LA-SS Manuel D'instructions

Replacing an Oven Light

1. Disconnect the oven from the power supply by means of
the switch used to connect the appliance to the electrical
mains, or unplug the appliance if the plug is accessible.
2. Remove the glass cover of the lamp-holder. (Fig. 15)
Fig. 15
3. Remove the lamp and replace with a lamp resistant to high
temperatures (572 F) with the following characteristics:
o
- Voltage: 120V
- Wattage: 25W
- Type: G9
- Lamp Type: Halogen
4. Replace the glass cover.
5. Reconnect the power to the oven.
To reorder the Furrion oven light bulb replacement, please
call Furrion service for assistance.

Replacing the Control Knob LED

WARNING
Any repairs to or installation of this appliance must be
performed by a qualified installer, service agency and in
accordance with the instructions in this manual.
1. Disconnect the oven from the power supply by means of
the switch used to connect the appliance to the electrical
mains, or unplug the appliance if the plug is accessible.
10
2. Grasp and pull on the control knob with the broken LED
light. (Fig. 16)
Fig. 16
3. Remove the two screws holding the LED light using a
Phillips screwdriver. (Fig. 17)
Fig. 17
4. Remove the LED assembly and disconnect the wire from
the base of the LED assembly. (Fig. 18)
Fig. 18
5. Plug the wire harness connector into the new LED
assembly.
6. Reattach the LED assembly to the console with the
2 screws removed in step 3. Ensure the wires are not
pinched during this process.
7. Reattach the control knob by aligning the stem of the
control into the opening in the control knob housing and
pushing it back into position.