Operation Of The Boiler - HTW PACIFIC Manuel De L'utilisateur Et D'installation

e. Physical damages occurred after the delivery of the device,
f. Damages due to tire and lightning,
g. Defects due to low or high voltage or due to not making the grounding.
h. Defects due to not performing the described periodic maintenance processes in time by our
authorized services,
i. Defects caused by other accessories and products used with the device,
j. Damages occurred due to freezing,
k. Distorting the registration label and warranty document,
l. Defects caused by operation outside the water conditions specified in the user manual The
repair of the above mentioned failures and damages are not covered by the warranty and is
being made against fee.
4. OPERATING OF THE BOILER
Make sure that the power, water and gas connections of the device are made and that the
necessary supply power is turned on.
a. Turn on the power connections.
b. Set the gas valve to the open position.
c. Press on (m]) button. Figure.1
d. Select Summer/Winter position. (Mode) Figure.1
WARNING:The device does not operate in summer position unless the water is turned on.
e. Ensure that the device operates by adjusting the temperature adjustment button to the
desired temperature degree.
WARNING: When operating the device for the first time, the device may break down by
indicating several times misfire until venting the air within the gas pipe out. In that case
press the (Reset) button for 5 seconds to restart your device again.
Domestic Water
Setting Buttons
On / Off Button
Summer / Winter -
Position Button
Figure.1
19
Heater Setting
_
Buttons
Reset Button