Installation Instructions; Startup - Eneo IPC-55C0000M0A Guide D'installation Rapide

Installation instructions

CAUTION: The camera's base should be attached to a structural
object, such as concrete, hard wood, wall stud or ceiling rafter
that supports the weight of the camera. If necessary use appro-
priate mounting material (e.g. anchors) instead of the material
enclosed with the camera.
• Make sure the power is removed before the installation.
• Follow the order for applying power.
Camera can work with PoE (IEEE Std. 802.3af ) and either 24VAC or 12VDC, dual voltage
power. It does NOT require the polarity-matched connection for 12VDC supply. Prima-
ry and secondary grounds are completely isolated to avoid the possible ground-loop
problems.
• Plug the network cable into RJ-45 Ethernet Port at the rear panel. If PoE is the
unique power, there will be no need to connect Power terminal.
•
(DC12V or AC24V), then plug the AC adapter to AC outlets to avoid an improper
reset from power jitter and a damage from the surge voltage when no load.
i When PoE and local dual power are connected at the same time, local power has
priority.
1. Remove the dust protection cap from the lens mount.
2.
3. Plug the lens plug into the lens connector on the side of camera case.
4. Mount the camera to the wall or ceilling with a corresponding mounting bracket
through the camera mount holes (1/4" thread insert) on its top or bottom.
CAUTION:
Care should be taken the cable is NOT to be damaged, kinked or
exposed in the hazardous area.
Do not expose the camera directly to a strong light source such
as the sun or spot light.
Start up
When the camera is powered properly, it starts up with initializing the internal
parameters.
EN
7