Troubleshooting; Warranty - AL-KO SnowLine 46 E Manuel D'utilisation Original

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 18

Troubleshooting

TROUBLESHOOTING
CAUTION!
Always unplug the mains plug and wait for the motor to come to a complete stop before perfor-
ming any work on the machine.
Problem
Motor does not
run
Machine does not
clear snow
Motor perfor-
mance is diminis-
hed.
Overload protec-
tion triggers
ADVICE
If problems are not listed in this table or you are unable rectify them yourself, please consult
our customer service department.

WARRANTY

We will address claims for any defects in materials and workmanship during the statutory period of limi-
tation by means of repairs or replacements of our choice. The period of limitation is governed by the laws
of the country in which the machine was purchased.
Our warranty applies only if:
The machine has been properly handled
The operating instructions have been adhered
to
Original replacement parts have been used
The warranty does not cover:
Damage to paint work through normal use
Parts subject to wear as indicated in the replacement parts list with a box [xxx xxx (x)]
Internal combustion engines – separate warranty conditions of the respective engine manufacturer
apply
The warranty period begins with the purchase by the first buyer. The warranty period begins on the date
that appears on the original purchase receipt. In the event of a warranty claim, please your contact supp-
lier or the nearest authorised customer service centre with this warranty declaration and the purchase re-
ceipt in hand. This warranty does not affect the legal warranty claims by the purchaser against the seller.
474 910_d
Possible cause
No mains power present.
Machine cable defective.
Auger or discharge chute clogged.
Drive belt torn or loose.
Too much snow in the discharge
chute.
Foreign objects in the auger
Solution
Check house fuse/extension cable.
Contact your AL-KO service centre/
authorised specialist.
Stop the motor, disconnect the ma-
chine from the power supply. Clear the
clogging.
Replace the drive belt.
Clean discharge chute/housing.
Remove the foreign objects
The warranty is no longer in effect if:
Efforts have been made to repair the machine
Technical modifications have been made to the
machine
The machine has not been used for its intended
purpose
17

Publicité

Table des Matières
loading

Table des Matières