Installation Requirements - Hofmann monty 1270 smart Mode D'emploi

i

Installation requirements

THE INSTALLATION SHALL BE CARRIED OUT
ONLY BY QUALIFIED PERSONNEL AND WITHIN
THE SCOPE OF THE INSTRUCTIONS PROVIDED
IN THIS MANUAL.
Install the machine in a covered and dry area.
The installation of the machine requires a free space
of at least 87"x106" (220x270cm) (Fig.i-1).
Make sure that from the operating position the user
can see all of the machine and the surrounding area.
The operator shall forbid, in such an area, the presence
of non authorized persons and of objects which may
create possible hazards.
i-1
The machine shall be installed on a horizontal floor
preferably even. Do not install the machine on a sinking
or irregular floor.
If the machine is installed on a raised floor, the floor
must have a capacity of at least 110lbsxsqft (5000 N/
m² o 500 kg/m²). The machine must be secured to the
floor through the holes provided in the cabinet.
Expansion screws 12x120mm shall be used.
Drill 12mm holes in the floor flush with the holes
provided in the cabinet.
Place the nogs into the holes drilled in the floor and
move the machine so that the holes of the cabinet are
flush with the holes in the floor. Tighten the screws at
51 ft lb (70 Nm).
x
Operator Manual
56