Publicité
Les langues disponibles
Les langues disponibles
Liens rapides
ASSEMBLY INSTRUCTIONS
TOOLS NEEDED FOR ASSEMBLY
13mm Socket or Wrench
ASSEMBLY INSTRUCTIONS
Mount push handle/brackets
assembly (Part #3) to the same
side of the cart as the swivel
locking casters using the four
stove bolts, washers, and
nuts provided.
Using 13mm socket or wrench
completely tighten all nuts.
Overall Load Capacity .............. 600 Lbs.
• It is the responsibility of the owner to make sure all personnel read this manual prior to using the device. It is also the
responsibility of the device owner to keep this manual intact and in a convenient location for all to see and read. If the manual or
product labels are lost or not legible, contact Sunex Tools ® for replacements. If the operator is not fluent in English, the product
and safety instructions shall be read and discussed with the operator in the operator's native language by the purchaser/owner or
his designee, making sure that the operator comprehends its contents. • Read and follow all instructions in User's Manual. • Do not
load carts beyond rated capacity (600 lbs.). • Lock lid and drawers before moving. • Apply brake on locking casters anytime cart
is in place. • Do not pull cart. Push from handle on end to move. • Units can tip or fall causing damage or personal injury. • Do not
stand on or step in drawers. • Do not open more than one loaded drawer at a time. • Cart is designed to roll easily on flat surfaces
and should not be used on uneven or inclined surfaces. • Keep children away from unit. • Wear gloves when lifting by edges.
• Failure to heed these warnings may result in personal injury and/or property damage.
WARNING: This product can expose you to chemicals including nickel, which is known to the State of California to cause cancer
and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
8057XTCAMO, 8057XTPK, 8057XTUSA1
SWIVEL
CASTERS
WARNING
Top Compartment Capacity ....180 Lbs.
8057XTCAMO, 8057XTPK, 8057XTUSA1
1
PREMIUM FULL DRAWER
SERVICE CART
SWIVEL
LOCKING CASTERS
Drawer Capacity ......... 70 Lbs. Each
© Copyright 2019, SunexTools
®
rev. 09/06/19
Publicité
Manuels Connexes pour Sunex Tools 8057XTCAMO
Sommaire des Matières pour Sunex Tools 8057XTCAMO
- Page 1 If the manual or product labels are lost or not legible, contact Sunex Tools ® for replacements. If the operator is not fluent in English, the product and safety instructions shall be read and discussed with the operator in the operator's native language by the purchaser/owner or his designee, making sure that the operator comprehends its contents.
- Page 2 SOLUTION: The inside lock / unlock slide potentially could fall out of its groove during shipment. Unscrew the four screws that are holding the lock / unlock slide in place. Once the screws are removed, simply place the latch back onto the slide and tighten the four screws back down. FIG. 1 MOUNTING SLOTS 8057XTCAMO, 8057XTPK, 8057XTUSA1 rev. 09/06/19...
- Page 3 PARTS BREAKDOWN PARTS LIST REF # PART # DESCRIPTION REF # PART # DESCRIPTION 8057TLMGC Top Lid– Matte Gray (8057XTCAMO) RS8057SCBK 5" Swivel Non Locking Caster– Black 8057TLMGP Top Lid–Matte Gray (8057XTPK) RS8057XTDHBK Drawer Handle–Black 8057TLW Top Lid–Off White (8057XTUSA1)
- Page 4 Si el manual o las etiquetas se hayan perdido o no sean legibles, comuníquese con Sunex Tools ® por algunos repuestos. Si el operador no domina el idioma inglés, las instrucciones del producto y de seguridad le serán leídas y discutidas con el operador en el idioma materno del...
- Page 5 Quite los cuatro tornillos que sujetan la corredera de bloqueo / desbloqueo en su lugar. Una vez retirados, simplemente vuelva a colocar la traba sobre la corredera y a ajustar los cuatro tornillos. FIG. 1 RANURAS DE MONTAJE 8057XTCAMO, 8057XTPK, 8057XTUSA1 rev. 09/06/19...
- Page 6 état et dans un endroit accessible permettant au manuel d'être vu et lu par tous. Si le manuel ou les étiquettes du produit sont perdus ou illisibles, contactez Sunex Tools ® pour les faire remplacer. Si l'utilisateur-opérateur de l'appareil ne maîtrise pas bien l'anglais, les instructions relatives au produit et aux mesures de sécurité...
- Page 7 SOLUTION: Il est possible que la glissière intérieure de verrouillage / déverrouillage soit sortie de sa rainure pendant le transport. Dévissez les quatre vis qui tiennent en place la glissière de verrouillage / déverrouillage. Ensuite, replacez simplement le loquet dans la glissière et resserrez les quatre vis. FIG. 1 LES RAINURES DE FIXATION 8057XTCAMO, 8057XTPK, 8057XTUSA1 rev. 09/06/19...