Télécharger Imprimer la page

Sunex Tools 8057XTCAMO Instructions D'assemblage page 2

Publicité

Les langues disponibles

Les langues disponibles

TROUBLESHOOTING
Hardware Specifications:
Handle
Hardware
4 pcs
Caster
Hardware
16 pcs
PROBLEM: Drawers appear not to fit, do not slide in accurately and bump the cart sides.
SOLUTION: The roller bearing slides must be fully engaged into the mounting slots on all drawers (see fig. 1 below). They potentially
could fall out of position during shipment. Check the side of the cart to determine which slide is out of position. Remove the drawer
that is out of position. The drawer is removed by the two clips on the actual roller bearing slide. Simply push the roller bearing slide
back down into position. Insert the drawer back onto the roller bearing slides.
PROBLEM: Back lock / unlock switch does not engage the drawer.
SOLUTION: The inside lock / unlock slide potentially could fall out of its groove during shipment. Unscrew the four screws that are
holding the lock / unlock slide in place. Once the screws are removed, simply place the latch back onto the slide and tighten the four
screws back down.
MOUNTING
SLOTS
8057XTCAMO, 8057XTPK, 8057XTUSA1
4 pcs
4 pcs
16 pcs
16 pcs
FIG. 1
2
rev. 09/06/19

Publicité

loading

Ce manuel est également adapté pour:

8057xtpk8057xtusa1