Function Mode - AFX SPIDER Manuel D'utilisation

Auto Test
Fixture Time
Firmware Version
Defaults
System Reset

Function Mode

DMX address setting
With this function, you can adjust the desired DMX-address via the Control Board.
1. Press the either the MENU, UP or DOWN buttons until "ADDR" is displayed, press ENTER.
2. The current address will now be displayed and flashing. Press the UP or DOWN buttons to find your desired
address. Press ENTER to set your desired DMX address.
Channel Mode
The unit has 12 or 43 channels that can receive the International DMX signal.
Show Mode
The user can select between【Sound】and 【Auto】mode
Slave Mode
In the【Slave mode】you can chose【Master】mode and【Slave】mode.
Black Out
Select 【YES】 or 【NO】 to black out or not
Sound State
Sound control 【ON】or【OFF】
Sound sensitivity
In this Mode a number between 0-100 will be displayed. Press the UP or DOWN buttons to adjust the sound
sensitivity, 0 being the least sensitive and 100 being the most sensitive.
Pan Reverse
Reverse the Pan-movement.
Tilt 1 Reverse
Reverse the Tilt 1-movement.
Tilt 2 Reverse
Reverse the Tilt 2-movement.
Tilt 3 Reverse
Reverse the Tilt 3-movement.
Back Light
Turns the LED display back light on or off
Auto Test
Theunit makes a self test.
Fixture Time ---0-9999
With this function you can display the running time of the unit.
©Copyright LOTRONIC 2015
Automatic test
0----9999
V104
YES,NO
YES,NO
9BEAM-FX Page 54