Modes; Timer Setting - Oceanic OCEASFBS2000W Guide D'utilisation

3. Modes

Press
−
: Low power operation (1000 w).
−
: High power operation (2000 w).
−
: Operation in automatic mode.
−
: Frost protection mode.
• In the mode low power
be defined.
Press
Note: The LED display shows the ambient temperature (room temperature)
near the heater, to achieve optimal indoor temperature, it is advisable to
increase the target temperature during the first hour of use of the device, then
you can adjust the temperature.
• Auto mode
temperature:
When the ambient temperature is lower than 17 °C,
the heater automatically default to work at high power:
When the ambient temperature is below 21 °C,
the heater automatically default to work at low power:
When the ambient temperature is above 21 °C, the heater
automatically stop working. (just blow the cold air)
• Frost protection mode

4. Timer setting

The timer setting can be made regardless of the mode.
After the mode has been selected, press the button "+"
the timer power on or on "-"
continue to flash, press
stops flashing means the timer start action.
Note: The timer is set in the same way for the control panel of heater and remote
control.
to select one of the 4 modes:
and mode high power
to set the target temperature when the display blind.
, the heater works at different power according to the room
the working temperature is 7 °C.
to select timer power off. Icon
to set the time needed, when the icon
the set temperature can
to select
34