GYS NOMAD POWER 500 Manuel D'utilisation page 12

Translation of the original instructions
FLASHLIGHT FUNCTION
PROTECTIONS
This device is protected against overload, overheating, overintensity, deep discharge, short circuit and polarity reversal.
TROUBLESHOOTING, CAUSES, SOLUTIONS
TROUBLESHOOTING
No answer while pressing the ON/
1
OFF button
2 Red LED on + beep
3 No LED on.
WARRANTY
The warranty covers faulty workmanship for 1 year from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported
12
NOMAD POWER 500
Press the ON/OFF button (9) for 3 seconds to turn on the LEDs.
Briefly press the button (9) to switch lighting modes (3 available modes:
normal, stroboscope and SOS).
CAUSES
The NOMAD POWER is discharged.
Short-circuit.
Polarity reversal.
The vehicle battery may be da-
maged.
SOLUTIONS
Charge the product.
Check that the clamps are well
connected and unplug/plug back the
jumper cable.
Check the polarity of the clamps and
disconnect/reconnect the smart start
cable.
Confirm that the connection of
the clamps is correct. Press the
""BOOST"" button and wait for the
GREEN LED to light up:
- If the GREEN LED lights up, at-
tempt a start within 30 seconds.
- If the GREEN LED does not light
up, do not attempt to start and
consult a professional.
EN