Duronic HV220 Manuel D'utilisation page 12

Operation
PLEASE READ THE INSTRUCTIONS IN FULL BEFORE USING THIS
HEATER.
- Turn the Power Switch Knob
to [OFF] position (Fig. 1 ).
- Turn the Temperature
Control Knob to [OFF] position
(Fig. 2).
2. Then plug in power cord to a
suitable electrical outlet.
(Rated not less than 1 O AMP)
At this moment, the light
indicator should be on.
3. Turn the Temperature
control knob clockwise to turn
the heater on. The heater will
heat the room to the chosen
temperature and then
automatically turn off. When
the indoor temperature drops,
the heater will operate again
and emit heat until the
temperature of the indoor
temperature reaches the
desired temperature. This
cycle will repeat to maintain
your chosen temperature. The
temperature can be altered by
turning the temperature control
knob.
12