Hama 00054119 Mode D'emploi page 3

G Operating instruction
Thank you for choosing a Hama product.
Take your time and read the following instructions and
information completely. Please keep these instructions in a safe
place for future reference.
1. Explanation of Warning Symbols and Notes
Warning
This symbol is used to indicate safety instructions or to draw
your attention to specific hazards and risks.
Note
This symbol is used to indicate additional information or
important notes.
2. Package Contents
• „Nano" Notebook Lock
• These operating instructions
3. Safety notes
Warning
Run the cable of the Notebook lock so that it does not pose
a tripping hazard or block emergency exits.
• Keep this product, as all electrical products, out of the reach
of children!
• Do not modify the product in any way. Doing so voids the
warranty.
4. Setting the combination number
Note
The combination is factory-set to '0000'.
• With a valid combination selected (factory-set „0000" or
personally stored code), push the reset button down with a
screwdriver and turn it 90° to the right.
• Set your new personal combination using the number wheels.
• Now turn the reset button 90° to the left to return it to its
starting position.
3
Note
• We expressly recommend writing the new combination
down and storing it in a safe place.
• We accept no liability for any damages resulting from lost
or forgotten combinations.
5. Connection and locking of Notebook lock
• Attach the cable to a xed object, e.g. foot of a table,
cupboard.
• Push the unlocking button on the lock down and hold the
button in this position.
• Insert the lock into the locking slot of the device to be
secured.
• Let go of the unlocking button.
• Now adjust the number combination.
6. Open the Notebook lock
• Enter the correct combination number.
• Push the unlocking button on the lock down and hold the
button in this position.
• Pull the lock out of the locking slot.
7. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and provides no
warranty for damage resulting from improper installation/
mounting, improper use of the product or from failure to
observe the operating instructions and/or safety notes.