Installation Of The Stop Limit Switches - Key Automation UNDER 900INT Manuel D'emploi

INSTALLING THE MOTOR REDUCER
1. Place the motor reducer gear unit inside the foun-
dation box.
2. Fix the motor reducer in place inside the founda-
tion box by tightening the 4 nuts.
3. Assemble the lever engine (1) on the motor shaft
and tighten the screw with washer switch (2).
4. Connect the lever engine (1) command to the
bracket (3) through the long lever (4) and secure them
together with screws M6x10 and washers supplied
data.
5. Connect the motor to the control panel following
the instructions in the manual installation of the card.
INSTALLATION OF THE LIMIT SWITCHES
1. Move the gate in a position fully closed, then
adjust the washer as shown below and fasten the
screw M10x35 .
4
1
2. Place the gate in the maximum open position,
and then attach the limit switch nut as shown in
the figure, and tighten the screw.
13
3
2