Assembly; Operation - EnerG+ HEA 22000BHR Manuel De L'utilisateur

MAKe SURe tHe HeAteR IS not FUnCtIonInG BeFoRe YoU HAnG It on A GAZeBo,
UnDeRneAtH A BALConY oR A RooF.
1. Make sure hook 'a' is well attached to the heater.
2. attach hook 'b' onto a secure post, beam or any solid attachment object. you can
also attach hook 'b' on hook 'a' going around an obstacle to install the heater.
note: wait until the heater heating element has cooled down before moving it.
3. Connect the heater to an aC 120V/60hz wall outlet.
4. pull on the switch cord to activate the heater. pull again to close it.
ReMeMBeR, portable electric heaters are designed for spot heating or as a supplementary
heat source. they are not intended to be the main source of heat during cold months.
overheat protection shut–off
If the heater overheat temperature is reached, it will automatically shut off.
the heater can only resume operation when the user resets the unit. please inspect and
remove any objects on or adjacent to the heater that may cause high temperature.
to reset the heater:
1. turn the heater off.
2. Unplug the heater.
3. after 5-10 minutes, plug the unit in again and operate normally.
Caution: you must always make sure there is at least 3 ft/50 cm of empty space above
and around the heater.
If you must use an extension cord, the cord should be at least no .14 aWg and rated for
no less than 1875 W.
pull on the switch cord to activate the heater at half power. pull again to activate at full
power (both heat lamps are open). pull on the cord again to shut the unit off.
I n S t r U C t I o n M a n U a L

2. aSSeMbLy

3. operatIon

www.EnErgplus.com p a g e 5