Changing Of The Position Of The Terminal Box - OEG CPA-E Serie Mode D'emploi

34 CPA-E and CPA-E S PWM series
4. Installation

4.3. Changing of the position of the terminal box

The terminal box can be rotated by 90°.
Steps required:
1. Please close the flow and return valves and release the pressure.
2. Loosen the four hexagon socket screws in the pump housing.
3. Turn the motor into the required position (see fig.).
4. Tighten the screws in CW direction.
5. Open the flow and return valves.
High-efficiency heating and solar circulation pumps
GB