Publicité
Les langues disponibles
Les langues disponibles
Operating instructions
PC USB Vibration Gamepad
Item no. 1388741
Intended use
The product is designed for control of games or similar software on a computer or a PlayStation 3.
2 vibration motors are integrated to make the game experience more realistic.
At that, the gamepad is connected to your computer via USB.
The power is supplied via a USB port as well.
The safety instructions must be observed at all times!
Any use other than described above may damage this product, there may also be other
dangers.
This product complies with the applicable national and European requirements. All names
of companies and products are the trademarks of the respective owners. All rights reserved.
Package contents
• USB Vibration Gamepad
• Driver CD Rom Ø 8 cm
• Operating instructions
Safety instructions
Please read all instructions before using this device, they include important
information on its correct operation.
Damage due to not following these operating instructions will void the war-
ranty! We do not assume any liability for any resulting damage!
We do not assume any liability for material and personal damage caused by
improper use or non-compliance with the safety instructions! The warranty
will be void in such cases!
• F or safety and licensing reasons (CE), unauthorised conversion and/or modifica-
tion of the product is not permitted.
• Protect the product from direct solar radiation, strong heat, cold and vibrations or
mechanical loads.
• The product must not get damp or wet, as this will destroy it.
• Do not leave packaging material carelessly lying around, since it could become a
dangerous plaything for children.
• Handle the product with care; it can be damaged by impacts, blows, or accidental
falls, even from a low height.
• If the product shows visible damages, do not use it any longer. Contact a profes-
sional or a qualified workshop.
• If you have any questions that are not answered in these operating instructions,
please contact our technical support centre or consult a professional.
Control elements
Version 03/16
°
A1
Button "1"
A2
Button "2"
A3
Button "3"
A4
Button "4"
A5
Control pad (left, right, up, down)
A6
"SELECT" button
A7
"MODE" button
Switches between the 2 operating modes "D-Input" and "X-Input"; in the "D-Input"
mode, the button can be used to switch between digital and analogue.
A8
"START" button
A9
Analogue joystick (left) with push buttons
A10
"TURBO" button; activates the burst function (if one of the digital buttons from A1 to A4
are pressed and held, the effect is the same as if the button is pressed again and again
in quick succession)
A11
Status LEDs (from left to right)
The 1st. LED is lit when the gamepad is connected with a PC or a PlayStation 3 using
USB
The 2nd. LED is lit when the gamepad is set to analogue in the "D-Input" mode.
A12
Analogue joystick (right) with push buttons
B1
Button "R1"
B2
Button "R2"
B3
Button "L1"
B4
Button "L2"
A hole is located on the bottom side of the controller labelled with "Reset". It does not
have a function in this version of the controller!
Publicité
