Weston 36-1901-W Mode D'emploi page 6

6. Insert the short, round end FIGURE 3
of the Handle Pivot Pin into the
Handle Post on the right side
of the Mixing Tub. Connect the
Handle Pivot Pin to the notched
end of the Mixing Shaft. Make
sure the flats on the Handle
Pivot Pin fully engage the notch.
FIGURE 3
Handle
Mixing
7. Place the Handle over the
Post
Shaft
exposed, tapered end of the
Handle
Handle
Retaining
Handle Pivot Pin. Line up the flat
Pivot
Knob
Pin
on the outside of the Handle Pivot
Pin with the flat on the inside of the
Handle. FIGURE 3
8. Insert the Handle Retaining
Knob through the Handle and
Handle Pivot Pin. Tighten the
Handle
Knob to secure the Handle.
DO NOT over-tighten the Handle
Retaining Knob to avoid
FIGURE 4
Clear Lid
excessive wear on the Handle
Handle
Pivot Pin.
9. Install the Clear Lid (figure
4). DO NOT use the Meat Mixer
without the Clear Lid in place.
Severe injury could result!
Mixing Tub
6