Fricosmos 061410 Mode D'emploi page 4

ENGLISH
Integral wall washbasin
electronic
Ref. 061410
Contents
- Sheathing for integral wall washbasin.
080608 - Design model wastepaper bin for integral washbasin.
060606 - Detachabkle Breastplate to fi t into integral washbasin.
080418 - 1 box dispenser of gloves, tissue or towels.
460219 - Stainless steel 800 ml. soap dosing device.
060804 - Electronic kit for washbasins and sinks.
454202 - 2 ½" Valve with trough for 500mm sink.
421240 - 60x5mm Hook.
409822 - Plastic nylon Fisher 6x30mm peg.
409824 - Plastic nylon Fisher 8x40mm peg.
421038 - Plate thread bolt 22x4,8mm. DIN 7981 A2.
421040 - Plate thread bolt 32x3,9mm. DIN 7981 A2.
Assembly
Check the contents.
Avoid dirt in pipes and in the area before assembly.
If the plumbing is new, let the water fl ow.
When assembling, it is advisable to use special gloves not to get cuts on hands.
Use teffl on to seal connexions.
Introduce the pipe in the upper orifi ce and fi x it the attached bolts ·
Open the control box and insert the supplied battery.
Connect the output of the non-return mixer to the input of the supplying knee ·
Connect the output of the supplying knee to the input of the control box ·
Connect the pipe of the control wire to the control box ·
Connect the hose to the control box · Fig. 1
Clamp the control box to the wall on a vertical position with the hose facing downwards
· Fig. 1
Assemble the discharge valve · Fig. 3
Fix the washbasin on the wall · Fig. 4
English
FRICOSMOS
Fig. 2
Fig. 1
Fig. 1
Fig. 1
You can now connect the water input and the discharge to the washbasin.
Adjust the desired temperature by turning the non-return mixing crown.
Insert the Breastplate from the top of the pan fl ap, slide it along the guides and fasten
it with screws on the previously fi tted wall plugs.
Clamp the complements to the wall on the Breastplate with its corresponding screws.
Clamp the wastepaper bin onto the wall on the desired spot and height with its wall
plugs and hooks · Fig. 4
Use
To let the water run, put your hands near the pipe sensor.
To stop the fl ow of water, withdraw your hands.
Temperature can be adjusted with the non-return mixer handle.
Maintenance
• Use only water and neutral soap when cleaning.
• Wipe with a soft cloth.
• Rinse with plenty of water.
• Dry with a soft cloth.
• Do not use acids or strong detergents and do not rub with a scourer or spatula.
• Change the battery each 2-3 years depending on use.
Safety
If the sensor is activated for a minute the water supply will stop automatically for your
safety.
No risks have been reported.
Available spares
080608 - Design model wastepaper bin for integral washbasin.
060606 - Detachabkle Breastplate to fi t into integral washbasin.
080418 - 1 box dispenser of gloves, tissue or towels.
460219 - Stainless steel 800 ml. soap dosing device.
060804 - Electronic kit for washbasins and sinks.
461604 - 1/2" M-H-M non-return mixer.
454202 - 2 ½" Valve with trough for 500mm sink.
460822 - Sensor of battery operated electronic kit.
460820 - Control box of battery operated electronci kit.
460824 - Spare battery for battery kit.
All sizes are described in mms.
English
FRICOSMOS