Klarstein Mariana Mode D'emploi page 18

EN
18
INSTALLATION
Preparation
If you have an outlet to the outside, your cooker hood can
be connected as below picture by means of an extraction
duct (enamel, aluminium, fl exible pipe or infl ammable
material with an interior diameter of 150 mm).
• Before installation, turn the unit off and unplug it from
the outlet.
• The cooker hood should be placed at a distance of
70-80 cm above the cooking plane for best effect.
Installation (Vent outside)
Note: When the range hood and appliance supplied with energy other than
electricity are simultaneously in operation, the negative pressure in the room must be
not exceed 4 Pa (4 x 10-5 Bar).
CAUTION
Risk of electric shock! Only use the supplied screws and fi xing devices
to install the extractor hood and follow the instructions in this manual.
Failure to do so may increase the risk of electric shock.