Lorell LLR42706 Instructions De Montage

Instruction Manual
Drywall Anchors
Phillips Screws
Key
1. Decide whether to mount the board vertically
or horizontally.
2. Remove the four black plastic corner covers
from the board. May need to use a small flat
tip tool to pry off these plastic covers.
3. Position the back of the board against the wall
in the desired location and use a pencil to
mark the holes in the four plastic corners. Set
the board aside.
4. Drill four ¼" diameter holes on the marked
wall. Insert an anchor into each hole.
5. Mount the board onto the wall and secure the
four plastic corners to the anchors with four
Phillips screws. Tighten the screws until
board is secured and put the covers back into
the corners.
6. Keys are included for locking and unlocking
the door.
®
PARTS & QUANTITY
PARTS
MOUNTING INSTRUCTIONS
Manufactured in China for S.P. Richards Co., Atlanta, GA
LLR42706
4 pcs
4 pcs
2 pcs
Enclosed Bulletin Board
LLR42706/42707
LLR42707
4 pcs
4 pcs
2 pcs
Black plastic corners
Figure 1
Lock
Open