Battery Replacement - GYS GYSPACK 400 Manuel D'utilisation

Translation of the original instructions

BATTERY REPLACEMENT

1
Product
GYSPACK 400
GYSPACK 600
To replace the battery :
• First the booster must be disconnected form the power supply.
• The back panel must be unscrewed (9 screws) and removed.
• Once the back panel is removed, the battery front appears (cf illustration). The battery is connected to the GYSPACK
at two points : at the - terminal
the connection between the battery and the GYSPACK.
When putting a new battery, make sure to observe the polarities of both the battery and the
GYSPACK. Terminal - on the left, terminal + on the right (cf illustration). Put the 2 screws and
washers back, tighten the nuts (recommended torque wrench 4 N.m).
• Place the booster's backpanel screws back on.
14
GYSPACK 400 / 600
Battery Type
6FM - 18
Lead-acid
battery
6FM - 22
1
and at the + terminal
Capacity
Voltage (V)
(Ah)
18
12
22
2
. To remove the battery, remove the screw that enables
EN
2
Dimensions
Battery ref
(cm)
33 x 14 x 43 53139
33 x 20 x 43 53151