Leckey Everyday Activity Seat Mode D'emploi page 18

7.13 Attaching the Push
Handle
For Size 1, the push handle is attached to the
chassis brackets by inserting the two lower
stems into the receiving tubes as shown (a).
For Size 2 and 3, the push handle is attached
to the seat base by inserting the two lower
stems into the receiving tubes as shown (b
and c).
The push handle has safety poppers which
need to be pressed in when inserting the
lower stems. Push the stems in until the
poppers protrude from the other end of the
receiving tubes. For Size 1 and 2, secure the
handle in place by tightening the bolt (d). For
Size 3, secure the handle by tightening the
locking knobs (e).
Check these regularly to make sure the bolt/
locking knobs are tight, particularly if you are
moving the product unit along corridors that
may have uneven or sloping surfaces.
A