IVT MK-1 Mode D'emploi page 4

Startup
After the device has been closed again and the coils are set, insert the plug into the mains power socket. Following the
connection to the 230 V outlet, an automatic test program will run.
- First, all LED's except the "Error" LED will light up.
- Approximately 2 seconds later, the LED's will go off in the following order: Automatic, Pipe Care
5 kHz, 3 kHz and the "1 kHz" LED will flash. The startup test is now finished. The green power LED is illuminated
continually.
Modes of operation
When the startup test is finished, the device will go into the 1 kHz mode. By pushing the Mode button, the device will switch
to the 3 kHz mode, by pushing the button again to the 5 kHz mode. In this mode of operation, the corresponding frequency
that has been selected will be active.
Pipe care
Switch the device to the 5 kHz mode. Now push the Mode button for approximately 2 seconds. The device now changes to
the "Pipe Care" mode. The yellow "Pipe Care" LED will go on and the 1 kHz,
3 kHz and 5 kHz LED's are illuminated alternately. In this mode of operation, the frequency fluctuates constantly between 1
to 5 kHz.
Automatic
Irrespective of the mode of operation the device is in, push the Mode button until the "AUTOMATIC" LED lights up. In this
mode, the following program will be started:
2 hours of pipe care
-
5 days of 1 kHz mode
-
- 2 hours of pipe care
- 5 days of 3 kHz mode
- 2 hours of pipe care
- 5 days of 5 kHz mode
After the program has been completed, the cycle will start again from the beginning.
Fault - If the "Fault" LED is illuminated, a short-circuit in the coil is likely. The most frequent causes for this fault are
damaged coils or contact of the coil end with the metal pipe.
Important notice!! The optimal effectiveness of the device is achieved in the "Automatic" mode since all programs run
consecutively. If your pipe systems have already become severely calcified, we recommend to operate the device in the
Pipe Care mode for approximately 4 weeks in order to dissolve the lime deposits more quickly. Subsequently, set the device
to the Automatic mode. Clean the shower heads and aerators in faucets more frequently in the beginning, since dissolved
lime particles can impede the flow of water.
Your multi-lime prevention device does not require maintenance.
Technical specifications
Operating voltage 230 VAC, power consumption 1.2 W, dimensions 160 x 80 x 40 mm
This multi-lime prevention device is warranted for a period of two years. Please note that errors in installation and operation
are beyond the scope of our responsibility. We disclaim any liability for damages occurring as a result of such errors.
GB Environmental protection information
When no longer in use, this product may not be deposited in the normal household waste but should be
brought to a collection point for the recycling of electrical and electronic appliances. A symbol on the
product, the operating instructions or the packaging draws attention to this.
The materials are recyclable as marked. By re-use, recycling or another form of using old appliances
you are making an important contribution towards the protection of the environment.
Please ask your local authorities for the appropriate disposal point.
We reserve the right to make technical alterations. We assume no liability for printing errors. 02/2006
IVT Innovative Versorgungs-Technik GmbH, Dienhof 14, D-92242 Hirschau
Phone: (49) 9622-719910, Fax: (49) 9622-7199120
www.IVT-Hirschau.de Info@IVT-Hirschau.de