Resetting The Picture Settings To The Factory Defaults - Samsung 4 Serie Manuel De L'utilisateur

Masquer les pouces Voir aussi pour 4 Serie:

Instructions d'utilisation (519 pages)

Manuel d'utilisation (425 pages)

Mode d'emploi (357 pages)

100

101

102

103

104

105

106

107

108

109

110

111

112

113

Table des Matières

Les langues disponibles

Screen Burn Protection

To reduce the possibility of screen burn, this unit is

equipped with screen burn prevention technology. This

technology enables you to set picture movement up/down

(Vertical Line) and side to side (Horizontal Dot). The Time

setting allows you to program the time between movement

of the picture in minutes.

− Pixel Shift: Using this function, you can minutely move

pixels on the PDP in horizontal or vertical direction to

minimize after image on the screen.

−

Set Pixel Shift to On by pressing the ▲ or ▼

button, then press the ENTER button.

−

Select the required option by pressing the ▲ or ▼

button, then press the ENTER button.

Available options: Horizontal Dot, Vertical Line,

Time

Optimum condition for pixel shift;

Horizontal Dot

Vertical Line

Time (minute)

This function is not available in the Just Scan mode.

The Pixel Shift value may differ depending on the monitor size (inches) and mode.

− All White: This function helps remove after images on the screen by changing the colour of

pixels to white. Use this function when there are remaining after images or symbols on the screen

especially when you displayed a still image on the screen for a long time.

− Scrolling: This function helps remove after images on the screen by moving all the pixels on the

PDP according to a pattern. Use this function when there are remaining after images or symbols

on the screen especially when you displayed a still image on the screen for a long time.

− Side Gray: When you watch TV with the screen ratio of 4:3, the screen is prevented from any

damage by adjusting the white balance on both extreme left and right sides.

Dark: When you set the screen ratio to 4:3, it darkens the left and right sides.

Light: When you set the screen ratio to 4:3, it brightens the left and right sides.

To remove after images on the screen, use either White or Scrolling function. Although both of

the two functions remove after images on the screen, Scrolling is more effective.

The after image removal function has to be executed for a long time (approximately 1 hour) to

effectively remove after images on the screen. If after image is not improved after the execution

of the function, repeat the function again.

Press any button on the remote control to cancel this feature.