Table des Matières
Publicité
Liens rapides
Publicité
Table des Matières
Manuels Connexes pour BE AC206
Sommaire des Matières pour BE AC206
- Page 1 PORTABLE AIR COMPRESSOR AC206 USER MANUAL...
- Page 2 Introduction Maintenance Using the Operator’s Manual 18 Maintenance Specifications 18 Daily 18 Weekly Product Identification 19 Monthly Record Identification Numbers 19 3 Months or 500 Operating Hours 19 12 Months or 1000 Operating Hours Safety Receipt and Inspection Caution Safety Instructions 19 Caution Hazard Symbols and Meanings Air Tank Warning...
-
Page 3: Record Identification Numbers
Using the Operator’s manual Thank you for purchasing a BE Air Compressor. Please take time now You will need to locate the model and serial number for the machine and to read through this manual so you better understand the machine’s record the information in the places provided below. -
Page 4: Receipt And Inspection
If you discover damage after receiving the air compressor (concealed to hazards. damage), the carrier must be notified within 15 days of receipt and an inspection must be requested by telephone with confirmation in writing. DANGER WILL cause DEATH, SEVERE INJURY or substantial On concealed damage claims, the burden of establishing that the property damage. -
Page 5: Air Tank Warning
Always wear eye protection that meets Read and follow all safely instructions for the material you are spray- ANSI Z28.1 specifications. ing. Be sure to use an approved respirator designed for use with your specific application. WARNING WARNING Keep hands and fingers away from exposed metal parts on a running air compressor. -
Page 6: General Safety Information
1. Read all manuals included with this product carefully. Be thoroughly 14. Fast moving air will stir up dust and debris which may be harmful. familiar with the controls and the proper use of the equipment. -
Page 7: Installation And Grounding
NSTALLATION AND LOCATION this may result in the loss of power and overheating of the motor. An The compressor must be used on a stable level surface. The air compres- additional air hose should be used instead of an extension cord. However, sor must be used in a clean and well-ventilated area. - Page 8 2. Place air compressor on a flat, level surface. 3. Pour supplied oil into crankcase until the oil level reaches the red dot in the oil level sight glass. Be careful not to overfill. 4. Install oil fill plug, supplied for compressor operation, before starting compressor.
-
Page 9: Operation And Adjustment
ON/OFF counterclockwise to increase or decrease the pressure (Fig.3). Engine Engine KNOB Start 3. The the compressor in running need be stopped only set the knob of pressure switch in positing off. FIG. 1 ADJUSTING SCREW 3. The engine is shipped without oil. Refer to the engine manual for oil capacity and viscosity recommendations. 4. Refer to engine manual to start your engine. - Page 10 7. If the release valve doesn’t work as motor stopped, find the cause from system before performing maintenance. immediately so as not to damage motor. 8. Lubricating oil must be clean, oil level should be kept in the score of NOTICE oil ruler.
-
Page 11: Exploded View
Exploded View EXPLODED VIEW LIST OF PARTS Item Description Item Description EXPLODED VIEW DIAGRAM Bolt M8 motor cover cylinder head bolt M5 Air filter Wind leaf cylinder seals circlip valve plate connector valve plate gasket fan cover valve clack nut M8 flap cylinder capacitance... -
Page 12: Troubleshooting Chart
LIST OF GOODS Troubleshooting Chart If you are experiencing a problem that is not listed in this chart, or have Designation checked all the possible cause listed and you are still experiencing the problem, see your authorized dealer. Air compressor Air filter Trouble Possible causes... - Page 13 POWER EQUIPMENT If you need assistance with the assembly or operation of your Compressor please call 1-866-850-6662...