Leifheit REGULUS AQUA POWERVAC Mode D'emploi page 18

REMOVING AND CLEANING THE CLEANING ROLLER
Figure 19
Remove roller cover (12) in order to remove the cleaning
roller (20).
To remove the cover, press release button (21) and remove
the cover.
Figure 20
Using the roller holder (19), remove the cleaning roller (20)
at the edge.
For this purpose, pull the holder upwards out of the guide.
Figure 21
Rinse the cleaning roller (20) and, if necessary, the cleaning
roller cover (12) under running water.
Allow the roller to completely dry before using again.
CAUTION: To avoid the formation of odour, remove
the cleaning roller after use and rinse out.
Insert only the completely dried cleaning roller
back in the appliance.
CLEANING THE VACUUM CHANNEL
Figure 22
When the cleaning roller is taken out, remove any soiling
on the nozzles (18) and vacuum channel (16) using a moist
cloth.
Special Leifheit cleaning brushes for the nozzles, the vacuum
channel as well as the water tanks can be purchased in the
trade or ordered from our customer services.
INSERTING THE CLEANING ROLLER AND CLOSING
THE ROLLER COVER
Figure 23
Make sure that the appliance is switched off and is
not charging.
First insert the cleaning roller (20) in the round mount
and then insert the roller holder (19) in the guide.
Figure 24
Insert the tabs of the roller cover (12) at the bottom end
in the matching mount and close the cover until you hear
it engaging
16
AUTO-WASH PROGRAM
In addition to cleaning your appliance, also use the
AUTO-WASH PROGRAM at regular intervals. When using the
program, some vinegar or vinegar cleaner can also be added
to the fresh water tank.
Before using the AUTO-WASH PROGRAM, always empty
the dirty water tank and put it tank back in. (7).
Figure 25
Fill the fresh water tank (6) with water up to the
AUTO-WASH MAX line.
Close the tank cover (23) and insert the fresh water tank
until you hear it engaging.
Figure 26
Place the appliance on the corresponding park position (22).
Keep the On / Off button (1) pressed together with the
Vacuum mode button I/II (2) for 3 seconds and then let go
as soon as the appliance starts the AUTO-WASH PROGRAM.
Then the operating display flashes green.
Figure 27
After 60 seconds, the program ends and the appliance
switches off.
Then remove the dirty water tank (7) and cleaning roller (20)
and wash-out.
DISASSEMBLING THE HANDLE
After assembling, do not remove the handle. Disassembly
of the handle is only intended if the appliance has to be
sent in for service purposes.
Figure 28
Loosen and remove the screw on the rear side of the appli-
ance.
Insert the screwdriver in the opening of the screw hole.
By applying slight pressure, the locking mechanism of the
handle can be released and the handle can be pulled out.