Correction Of Malfunctions - WAGNER Renuvo Manuel D'utilisation

Renuvo

11. Correction of Malfunctions

Problem
•
A. Not enough
material is
•
coming out
•
•
•
•
•
•
B. Too much
material is
•
coming out
•
C. No material
comes out
•
at all
•
D. Application
of material
•
does not
cover surface
(stripy)
•
E. Renuvo leaks
•
•
Cause
The material limiter is set to the
upper position
Container empty
Trigger is not pressed very often.
Container not inserted properly
Remains of material around the
container valve
Container valve blocked
Material too thick
Material limiter is set to the lower
position
Trigger is pressed too frequently.
Tube loose in container or
blocked
Not enough material in the
container
Not enough material on the
application pad
Application pad and/or groove
brush damaged
Container not inserted properly
Application pad not mounted
correctly
Remains of material around the
container valve
Remedy
➞ Push the limiter down
➞ Refill container
➞ Press the trigger more
frequently/for longer periods
➞ Insert properly
➞ Clean (see fig. 13, a)
➞ Clean (see fig. 16 and 17)
➞ Dilute according to
manufacturer's instructions
➞ Push the limiter up
➞ Press trigger less frequently/
for shorter periods
➞ Secure tube or clean (see fig.
15)
➞ Refill container
➞ See solutions suggested in
section A
➞ Replace
➞ Insert properly
➞ Mount application pad
securely
➞ Clean (see fig. 13, a)
GB
17