Jays m-Seven True Wireless Guide Rapide page 7

EN English
Getting started
Power on/off and pairing
To power on, place the earpieces in the charging case then take them out of the
charging case, both earpieces at the same time. The LED on bothearpieces will
flash in white. Once the two earpieces have connected to each other, the LED on
the left earpiece will turn off and the LED on the right earpiece will flash in red and
white as the earphones enter pairing mode automatically. To pair, go to Bluetooth
settings on your device and select "JAYS m-Seven True Wireless". The LED on the
right earpiece will turn off upon a successful connection.
To power off, place the earpieces in the charging case and they will turn off
automatically. If the Bluetooth
®
will turn off automatically after 3-5 minutes.
Reconnecting and additional pairing
The earphones will automatically try to reconnect to the most recently used
device when both earpieces is taken out of the charging case.
Using the charging case
To charge, place both the earpieces in the charging case, the charging will begin
automatically. The charging is indicated by the LED flashing in red on both
earpieces. When the LED turns off, the earphones are fully charged.
The battery level of the charging case is indicated by the four white LEDs on
the front of the charging case. Press the button on the back of the charging case
to check the battery level. One light, 25% battery. Two lights, 50% battery.
Three lights, 75% battery. Four lights 100% battery. Charge the charging case
by connecting the included cable to the bottom of the charging case and any
certified USB power output. A full 100% charge will take around 2.5 hours
(depending on temperature and charger).
Battery status
When the LED on the earpieces flash in red, the battery level is running low.
Resetting the earphones
To reset the earphones, place both earpieces in the charging case and ensure
them to fully touch with the pogopins. Place a finger on the center of top of
both left and right earpiece and keep them there until the LED on both
earpieces flashes twice in purple as the earphones reset. Please note there are
about 2-3 seconds between the first and second flash. Lift both earphones out
of the box simultaneously. The earphones will now enter interconnection mode
and try pairing to each other. When the left earphone indicator turns off and the
right earphone indicator flashes in white and red light, switch off and on your
Bluetooth on your device then connect it with your m-Sevens.
on the paired device turns off, the earphones
Troubleshooting
Problem pairing and connecting
• Make sure the earphones are not connected to another device.
• Disable and enable Bluetooth on your device.
• Move the earphones closer to the device or alter their positions
to avoid Bluetooth interference.
• Verify no other wireless equipment interfere with your earphones
®
Bluetooth signal.
• If the earpieces does not pair with eachother, reset the earphones.
Follow instructions above.
Problem with sound transmission
Move the streaming device to another position. Your body, distance, different
materials and other wireless equipment can interfere with the wireless signal
between your device and earphone.
FAQ and quickstart guide
Visit jaysheadphones.com for more instructions and help on this product.