Fral FLIPPERDRY 200 Manuel D'utilisation Et D'entretien page 7

Déshumidificateur
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

1 SAFETY INSTRUCTIONS
7 ELECTRIC DIAGRAM
• The machine must be always connected using earthed electrical plugs as required for all electrical
appliances; the Company declines any responsibility for any danger or damage whenever this norm is
not complied with.
• Any Intervention on the machine using any Instrument must be carried out only by a qualified techni-
cian.
• When the machine is connected with a power socket, It must be in vertical position and any rough move
must be avoided because it could cause some water to come into contact with electrical parts; it is the-
refore recommended to remove the plug from the socket before moving around the dehumidifier; if any
water may have been spread on the machine, following some rough handling of the same, then the
dehumidifier must be turned off and can be started up again only after 8 hours.
• Correct Distance: the dehumidifier draws in the air from the back and lets out through the front side gril-
le: therefore the back panel, which supports the air filter, must be kept at a minimum distance of 15 cm
from the wall.
• The dehumidifier, moreover, must not be set running in narrow areas, which do not allow a proper dif-
fusion in the room of the air coming out from the grille. It is, instead, allowed, to set the machine sides
near the walls.
• The machine has been designed and manufactured in compliance with the strictest safety rules.
Therefore, pointed instruments (screw drivers, wool needles or similar ones) are not to be inserted in the
grille or in the opening of the back panel when it is opened to remove the filter. 1
• The machine must not be cleaned using water. To clean the dehumidifier, it should be used a wet cloth.
Remember to disconnect the plug from the socket before.
• The front panel should not be used to lay over it clothe or other things: it could cause damages or dan-
gers.
USE AND MAINTENANCE
INSTRUCTION MANUAL
INDEX
1. SAFETY WARNINGS
7
pag.
7
pag
8
pag
8
pag.
9
pag.
10
pag.
10
pag.
19

Publicité

Table des Matières
loading

Produits Connexes pour Fral FLIPPERDRY 200

Ce manuel est également adapté pour:

Flipperdry 300Flipperdry 400

Table des Matières