Assembly - Klarstein VINAMOUR 29D Mode D'emploi

EN
24

ASSEMBLY

Fixing the handle and reversing the door of the wine cooler
1. Install handle to the door frame of the appliance.
The handle is delivered in a separated package along with the required screws.
(1) Reveal two small holes on the inner
side of the door frame by lightly pulling the
door seal out.
(2) Line the handle up with the holes and
insert the screws from inside.
(3) Screw them up with a screw-driver.
(4) Replace the door seal to cover the
screws.
2. Reversing the door
Our wine cooler is delivered with the door opening from left to right. To reverse the
opening direction:
1 Close the door.
(1) Take off the door hinge cover
2
on the up right corner. (2) Unscrew
the flange screws. (3) Take off the
door hinge. (4) Remove the up left
side cap.
(5) Lift the door up until the door gets
3
off the lower door hinge.
4 Unscrew the lower door hinge.