Publicité
Les langues disponibles
Les langues disponibles
Release the trigger and turn the on/
off switch to "O" position. Turn Off the
water supply tap.
NOTE: When not in use, push the
lock-out up until it clicks into the
slot.
Select the right nozzles
Select the suitable nozzle for different
cleaning jobs.
Nozzle 25
(green) is applicable for
0
cleaning on concrete, bricks and
masonry.
Nozzle 40
(white) is applicable for
O
cleaning on wooden and other soft
objects.
The soap nozzle is applicable for soap-
ing while other nozzles cannot be used
to do it.
Turbo nozzle is applicable for cleaning
on concrete, bricks and masonry.
WARNING: Do not change the
nozzle pattern when the tool is
powered on.
Cleaning
Begin with the nozzle 1-2ft away from
the surface and approach with caution
until it reaches the desired position
for overly close spray may do harm to
surface.
WARNING: Do not connect the
machine to water supplies that
are dirty, rusty, muddy, or corrosive.
(Including window cleaning liquids,
plant foods, or fertilizers etc.)
Add and use detergent
Install the soap nozzle before opera-
tion. The detergent will automatically
be drawn through the wand when the
soap nozzle is being used.
NOTE: If necessary, use a funnel (not
supplied)to prevent accidental over-
flows of detergent outside of the tank.
Use the hose reel
NOTE: pull the Hose Reel Handle out
and uncoil hose from the hose reel
before use.
Using the power cord holder
To wind or unwind the power cord, pull
out the power cord holders and then
turn outwards or inwards.
MAINTENANCE
Remove plug from the socket before carrying out
any adjustment, servicing or maintenance.
Inspect the product for damaged or worn parts before each
Electric Pressure Washer
use. Do not operate it if you find damaged or worn parts.
See Fig. H1,
Contact your supplier or the manufacturer for replacement
H2
parts.
Power cord maintenance
If the electrical cord is damaged, do not attempt to repair
yourself; call the Worx solutions center for further assistance.
Pump maintenance
See Fig. I
Inspect the pump frequently whether any leaking occurs
around the pump seal. If leaking occurs, please contact the
solutions center for further assistance.
Nozzle maintenance
Remove the nozzle from the lance, then remove any possible
obstructions using the included declogging needle (See
Fig. N).Then use a garden hose to rinse the nozzle by
backwashing.
STORAGE
1. Disconnect the water source. Turn on the pressure
washer for a few seconds to assist with removing any
remaining water. Then, quickly turn it off.
2. Unplug the power supply and wind power cord around
See Fig. J
the reel. (See Fig. M1)
3. Disconnect the high-pressure hose and garden hose (not
supplied).
4. Tilt the unit to allow any remaining water to drain out of
the pump, through the water inlet.
5. Store in a frost-free location with a temperature above
0°C(32°F). (See Fig. O)
NOTE: Regular usage of a pump protector will prevent
freeze damage and prolong the life of the pump. (See
Fig. P1, P2)
See Fig. K1,
K2, K3
See Fig.L1,
L2, L3
See Fig. M1,
M2
11
EN
Publicité
