AbleNet Lingo Guide De Démarrage Rapide

Quickstart Guide:
Lingo
®
wearable messaging and communication aid
Overlays and ideas at www.ablenetinc.com
3
Record Single Messages
Press and
Hold while
speaking
Press and Hold the message location, begin speaking
when you hear a beep. Release when finished.
Repeat for additional message locations.
(Up to 25 seconds for locations 1-7.)
NOTE: Record Light will flash Red while recording, Yellow
when only ten seconds remain.
1
Charge and Turn On
On
Battery Status Light
Charge
Plug the included wall adapter into the side of Lingo
and charge until the Battery Status Light turns GREEN.
NOTE: When charging from very low charge (Flashing RED),
three hours are required for a full charge.
NOTE: When Lingo needs to be charged, the Battery Status
Light will flash Red three times.
4
Record Sequential Messages
Repeat Step 3 for sequential messages in the location
shown.
(Up to 60 seconds for this location.)
NOTE: Record Light will flash Red while recording, Yellow
when only ten seconds remain.
2
Enter Record Mode
Press and
Release
Press and Release the Record button. The Record Light
activates.
NOTE: The Message Status Lights will also indicate their
availability. Red = Recorded, Yellow = Blank
5
Exit Record Mode
Press and
Release
Repeat
Press and Release the Record button to exit Record
Mode. Your Lingo is ready for use.
NOTE: Repeat Steps 2, 3, and 5 with the Erase button to
erase messages in any location.