Publicité
and dry location and should place the
battery in cool and dry environment.
4. Do not place the battery in high-temperature
locations, such as near a fire, heater, etc.
5. Do not reverse the positive terminal and
the negative terminal of the battery.
6. Do not connect the positive terminal
and the negative terminal of the battery
to each other with any metal objects.
7. Do not knock, strike or step on the battery.
8. Do not solder directly onto the
battery and pierce the battery with
nails or other edge tools.
9. In the event that the battery leaks and
the fluid gets into one's eye, do not
rub the eye. Rinse well with water.
10. Immediately discontinue use of the battery,
if, while using the battery emits an unusual
smell, feels hot, changes color, changes
shape, or appears abnormal in any other way.
11. If the supply cord is damaged,it must
be replaced bymanufacturer, its service
agent or similarly qualifiedpersons
in order to aviod a hazard.
4. ENVIRONMENTALLY SAFE
BATTERY DISPOSAL
The following toxic and corrosive
materials are in the batteries used in this
tool battery pack:
Li-ion, a toxic material.
All toxic materials must be disposed
of in a specified manner to prevent
contamination of the environment. Before
disposing of damaged or worn out
Lithiumion battery packs, contact your
local waste disposal agency, or the local
Environmental Protection Agency for
information and specific instructions. Take
the batteries to a local recycling and/or
disposal centre, certified for Li-ion disposal.
If the battery pack cracks
or breaks, with or without
leaks, do not recharge it and do not use.
Dispose of it and replace with a new battery
pack. DO NOT ATTEMPT TO REPAIR IT!
To avoid injury and risk of fire,
explosion, or electric shock, and to
avoid damage to the environment:
– Cover the battery's terminals with
heavy-duty adhesive tape.
– DO NOT attempt to remove or destroy
any of the battery pack components.
– DO NOT attempt to open the battery pack.
If a leak develops, the released
electrolytes are corrosive and toxic.
DO NOT get the solution in the eyes
or on skin, and do not swallow it.
– DO NOT place these batteries in
your regular household trash.
– DO NOT incinerate.
– DO NOT place them where they will
become part of any waste landfill
or municipal solid waste stream.
– Take them to a certified recycling
or disposal centre.
5. BATTERY CHARGER
SPECIFICATIONS
24V charger: CG 24 Li
Input: 100-240V ~ 50/60 Hz, 1.1A
Output: 24V
• The apparatus shall not be exposed to
dripping or splashing and no objects
filled with liquids, such as vases,
shall be placed on the apparatus.
• Charger is Li-lon rechargeable batteries.
Other types of batteries may burst and
causing injury to persons and damage.
• Charging only rechargeable Batteries.
• LED turns green blinking during charging,
and green during after charging.
• The disconnection from line voltage
is made by pulling the mains plug.
• The socket outlet must be located close to
the machine and be easily accessible.
CHARGING PROCEDURE
NOTE
The battery is not shipped fully
charged. It is recommended to fully charge before
use to ensure that maximum run time can be
achieved. This lithium-ion battery will not develop
a memory and may be charged at any time
1. Plug the charger into an AC power outlet..
2.Insert the battery pack (1) into the charger (2).
EN - 3
3A
Publicité
Chapitres
