Numan Drive Mode D'emploi page 32

1. Turn the
SOURCE/SPEAKER
the remote control until the BT indicator lights up.
2. After a few seconds, the BT LED will flash. This means that the unit is in search mode and can detect other
BT units.
3. Activate BT on the mobile device you want to connect to the amplifier. The device is displayed in the device
list of the mobile device as „NUMAN Drive". Select this from the device list to establish a connection.
4. If you need to enter a password, enter „0000" to agree to the connection.
5. After the connection has been successfully established, the BT LED will light permanently white and stop
flashing.
BT CONNECTION
knob on the front panel of the unit, or press the buttons
32
of
INPUT UP/DOWN