Publicité
Les langues disponibles
Les langues disponibles
7. Benutzung
7.1 Charging battery pack
Push the battery pack completely to the stop on the sliding
seat (2).
The operating indicator (3) flashes.
Note: To have the charge level displayed on Li-ion battery
packs, first take the battery pack out of the charger and then
press the button on the battery pack.
7.2 Conservation charge
Once the charging process has finished, the battery charger
automatically switches to conservation mode.
The battery pack can remain in the battery charger and is
therefore always ready for use.
The operating display (3) lights up continuously.
8. Faults
8.1 Warning display (4) lights up continuously
Battery pack is not charged. Excessive/insufficient tempera-
ture. When the temperature of the battery pack is between
0 °C and 50 °C, the charging process begins automatically.
8.2 Warning display (4) flashes
• Battery pack is defective. Remove the battery pack
immediately from the charger.
• The battery pack was not pushed correctly onto the
sliding seat (2). See chapter 7.1.
9. Repairs
Repairs to the charger must only be carried out by qualified
electricians.
If the mains connection cable of this device is damaged, it
must be replaced by the manufacturer or the Customer Ser-
vice department of the manufacturer or a similarly qualified
person to prevent endangering personnel and property.
If you have charges that require repairs, please contact your
service centre.
See for www.birchmeier.com addresses.
10. Environmental Protection
Observe national regulations on environmentally compatible
disposal and on the recycling of disused machines, packa-
ging and accessories.
Only for EU countries: never dispose of power tools
in your household waste! According to European
Directive 2012/19/EU on Waste from Electric and
Electronic Equipment and implementation in national law,
used power tools must be collected separately and recycled
in an environmentally-friendly manner.
11. Technical Specifications
See page 2.
U = voltage ranges of the battery packs
C = battery pack capacity
I
= charging current
C
t
= charging time
1)
Depending on the residual capacity and the temperature
1)
of the battery pack, real charging times may deviate from
the specifications.
Recommended ambient temperature when charging: 0 °C
to 50 °C
Changes due to technological progress reserved.
Device of protection class II
~
AC Powe
EN
7
Publicité
