Pentair ControlBrite Guide D'installation page 5

Make sure to check and comply with your local technical regulations and building codes in particular
regarding minimal safety distances for installation of electrical components near a swimming pool.
Only a qualified service person should install the product.. Before installing this product, refer to the
Important Warning and Safety Instructions
Respect safety distance between the pool and the ControlBrite system (electric appliance) as
required by local regulation
The Interface Module and Contactor have to be accommodated inside a DIN rail cabinet. 36mlm of free space is
required for the product.
The remote control should be stored in a dry environment and protected from direct sunlight.
It is required to protect it from rain or water projections (water sprinklers). It is possible to fix the unit on a flat vertical
surface using the screws and anchor plugs supplied with the unit.
The remote control uses one 12V type 23AE battery.
The picture below shows the connectors on the ControlBrite Interface module and their function. A blinking 'lights'
LED indicates an error condition. The output for the lights is a dry contact. Connect the transformer after the
Controlbrite as indicted in the below schedule. If the total consumed power of the lights is more then 100W, use a
relay.
Antenna
L
230V N
In most cases the antenna supplied with the system is sufficient. It is however possible to connect an external antenna
to increase performance of the remote control. In such case connect the core of the cable to ANT and the metallic
shielding to GND.
* On publication of this manual only Controlpro+ allows to be connected to Controlbrite.
Connection to ControlPro *
Transformator
230V 12V
IntelliBrite
5