Evercraft Air Tools 776-9264 Guide D'utilisation page 6

AIR DRILLS
TOOL WILL NOT RUN, RUNS SLOWLY, AIR FLOWS SLIGHTLY FROm ExHAUST, SPINDLE TURNS FREELY —
This is prob a bly caused by: air flow blocked by dirt build-up; motor parts jammed with dirt.
YOU SHOULD: Check air inlet for blockage. Pour a generous amount of air tool oil into air inlet. Operate trigger
in short bursts. Detach air supply; turn empty and closed drill chuck by hand. Reconnect air supply.
TOOL WILL NOT RUN. AIR FLOWS FREELY FROm ExHAUST. SPINDLE TURNS FREELY — This is prob a bly
caused by: Build up of dirt or varnish on rotor vanes.
YOU SHOULD: Pour a generous amount of air tool oil into air inlet. Operate trigger in short bursts. Detach air
supply; turn empty and closed drill chuck by hand. Reconnect air supply.
TOOL LOCkED UP, SPINDLE WILL NOT TURN — This is prob a b ly caused by: a broken motor vane; gears
broken or jammed by foreign object.
YOU SHOULD: See 90 day limited warranty.
TOOL WILL NOT SHUT OFF — This is prob a b ly caused by: throttle valve O-ring blown off seat.
YOU SHOULD: See breakdown for part number and replace O-ring or see 90 day limited warranty.
AIR HAmmERS
TOOL WILL NOT RUN — This is prob a b ly caused by: cycling valve or throttle valve clogged with dirt or sludge.
YOU SHOULD: Pour a generous amount of air tool oil into air inlet; check for dirt. Operate trigger in short bursts
(chisel in place and against solid surface). If not free, detach air supply. Tap nose or barrel lightly with
plastic mallet, reconnect air supply, and repeat above steps. If still not free, detach air supply, insert a 6"
piece of 1/8" diameter rod in nozzle and lightly tap to loosen piston in rear direction. Reconnect air
supply and repeat above steps.
CHISEL STUCk IN NOzzLE— This is prob a bly caused by: the end of the shank is misshapen.
YOU SHOULD: See 90 day limited warranty.
NOTE: Disassembly of this tool by other than an authorized service center
90 DAY LImITED WARRANTY: EVERCRAFT air tools are warranted to be free from defects in material
and workmanship. If any unit proves to be defective in material or workmanship within 90 days from the
original date of purchase, it will be replaced free of charge. In the unlikely event a replacement is required,
return the unit to the place of purchase for a free replacement. To obtain service after the 90-day limited
warranty, please visit www.toolwarrantyrepair.com for a complete list of authorized air tool centers. Any
repair cost incurred, along with freight, will be the sole responsibility of the consumer.
The foregoing obligation is Balkamp Inc. sole liability under this or any implied warranty, and under no
circumstances will Balkamp Inc. be liable for any incidental or consequential damages
PLEASE REVIEW ALL WARNING INSTRUCTIONS PRIOR TO OPERATION.
776-9264
WILL VOID the war r an t y on this tool.
SAVE ThIS mAN U AL fOR fUTURE REf ER ENCE.
6 Rev. 06/16/10