Machine Installation And Preparation; Checking For Damage; Environmental Conditions; Positioning - ilco Silca Bravo III Manuel D'instructions

BRAVO III with EZ-Jaw
5

MACHINE INSTALLATION AND PREPARATION

The BRAVO III with EZ-Jaw key-cutting machine can be installed by the purchaser and does not require
any special skills.
The machine is supplied ready for use and does not need to be set up. However, some checks and
preparation for use need to be carried out by the operator.
5.1

Checking for damage

The BRAVO III with EZ-Jaw key-cutting machine is solid and compact and will not normally damage if
transport, unpacking and installation have all been carried out according to the instructions in this
manual.
However, it is always advisable to check that the machine has not suffered any damage.
5.2

Environmental conditions

To ensure that the best use is made of the BRAVO III with EZ-Jaw key-cutting machine, certain
parameters must be borne in mind:
- damp, badly ventilated sites should be avoided.
- the ideal conditions for the machine are:
5.3

Positioning

Place the key-cutting machine on a horizontal surface, solid enough to take the weight.
To facilitate operation and maintenance, install the machine with a clearance of at least 200 mm on all
sides (fig.8).
Ensure that the machine stands perfectly balanced on the four feet. Vibration is avoided when the
machine is properly set on the horizontal plane.
ATTENTION: ensure that the machine voltage is the same as that of the mains, which must be properly
earthed and provided with a differential switch.
Fig. 8
12
temperature: between 10 and 40 °C
relative humidity: approx. 60%
200 mm
200 mm
Copyright Silca 2010
Operating manual - English
200 mm